Kyosho Mini Inferno Front Suspension Holder by 3Racing MIF-025/BU  [MIF-025/BU]

Front suspension holder overview

This front suspension holder is an RC-scale replacement part intended for the Kyosho Mini Inferno chassis, supplied under the 3Racing MIF-025/BU designation. It serves as a dedicated mounting point in the vehicle's front suspension assembly and is intended for hobby use on 1/18 scale Mini Inferno models.

Fit and compatibility: the part is described for the Mini Inferno line so confirm the holder aligns with the existing chassis mounting points and shock locations before final assembly. Visual check and a test fit are recommended to ensure correct orientation and clearance with steering and shock components.

Installation and setup notes: install using the same mounting holes and hardware pattern as the original holder where possible, tighten fasteners progressively to avoid misalignment, and verify that steering travel and suspension droop remain unobstructed. During setup, use this holder to stabilize the front mounting geometry as part of camber and toe adjustments when tuning handling.

Tuning role: this holder provides a fixed interface for the front suspension geometry, making small adjustments to ride height, shock position, and wheel alignment more repeatable during setup sessions on carpet or outdoor surfaces.