KYOSHO Mini Inferno Graphite Rear Shock Tower Half8 by 3Racing MIF-009/WO  [MIF-009/WO]

Graphite rear shock tower half for Mini Inferno

This is an RC-scale rear shock tower half designed for the Kyosho Mini Inferno chassis, produced by 3Racing as part MIF-009/WO. Made from graphite material, the component replaces the rear shock tower half to provide a stiffer mounting point for the rear suspension on the Mini Inferno platform.

Installation is straightforward for hobbyists familiar with Mini Inferno maintenance: remove the existing rear shock tower half, transfer the shock mounts and any existing hardware, and fit the graphite part using the original mounting points. No special tools beyond standard hex drivers are required, and retention of factory hardware is typical to ensure correct alignment.

From a tuning perspective, a graphite rear shock tower half alters the rear end stiffness and mounting rigidity, which can affect suspension responsivity and chassis balance. Use this part when testing changes to shock mounting geometry or when seeking reduced flex at the rear during aggressive cornering. Check fasteners regularly and inspect mounting holes for wear during setup and after running sessions.