This GPM aftermarket front arm plate is made for Kyosho Mini Inferno ST, Mini Inferno, and Mini Inferno 09 chassis as a direct RC-scale accessory to support the rear gear box area. The part is supplied in blue graphite finish and intended to replace the stock front arm plate where chassis layout and rear gear box clearance match the listed Mini Inferno models.
The plate's role is structural and tuning-oriented: it ties the front arm mounting points to the rear gear box section, helping maintain suspension geometry under load and offering a stiffer interface compared to some stock plastic parts. It is useful when adjusting roll center or when fitting heavier aftermarket components that benefit from a more rigid mounting surface.
Installation notes: prepare basic RC hand tools, remove the existing front arm plate and fasteners, verify alignment with the rear gear box mounts, then re‑use OEM screws or equivalent hex fasteners to secure the graphite plate. Check clearance for suspension travel and driveline movement after installation. The package contains 1 pcs of the plate in blue graphite.
Compatibility and tuning tips: confirm fit on the target Mini Inferno variant before final assembly, inspect mating faces for burrs, and consider using low‑strength threadlocker on metal fasteners if frequent disassembly is not needed. The plate is intended for RC chassis use only and not for any real vehicle applications.
Copyright © 2008-2026 rcjaz.com All rights reserved
