Kyosho Mini Inferno ST Glass Fibre Front Arm Plate for Front Gear Box by GPM GLFMIF008F  [GLFMIF008F]

Front arm plate for Mini Inferno ST

This replacement front arm plate is intended for RC-scale use on the Kyosho Mini Inferno ST where the front gear box interface requires a glass fibre plate. The part is produced by GPM and sold as a single piece suitable for repair or incremental setup changes on the Mini Inferno ST chassis.

Functionally the plate locates at the front gear box area and contributes to suspension geometry stability by securing the arm pivot points. As a glass fibre component it provides consistent stiffness compared with typical plastic parts without implying properties for full-size vehicles; references here are strictly RC-scale.

When fitting, verify orientation and mating surfaces at the front gear box to avoid misalignment. Check existing fasteners and thread engagement where the plate secures to the chassis to maintain correct pivot clearance. The part is designed to replace the stock front arm plate while keeping the vehicle’s standard mounting points.

In tuning terms this plate is best treated as a wear or stiffness replacement: swapping a worn or damaged plate restores original geometry, and choosing a stiffer or more compliant plate can slightly affect front-end feedback during setup iterations. Keep setup notes when testing changes so adjustments can be correlated to handling differences.