Kyosho Mini Inferno / Mini Inferno ST Rear Brace Stiffener by 3Racing MIF-015/TI  [MIF-015/TI]

Rear brace stiffener for Mini Inferno

This rear brace stiffener is a scale RC accessory made for the Kyosho Mini Inferno and Mini Inferno ST chassis, supplied under 3Racing part MIF-015/TI. It is finished in silver and intended to work with the vehicle's rear brace area to provide a firmer rear chassis response when tuning handling.

Compatibility is limited to the models named above, the component installs at the existing rear brace area and uses the car's original mounting points. No extra cutting or chassis modification is required beyond standard removal of the stock brace, but verify fit before final tightening.

From a tuning perspective, adding a rear brace stiffener changes how the rear end transfers loads to the suspension and diff. Expect adjustments to handling balance when combined with different dampers or tyre choices; use setup changes in small increments and test on-segment to judge effects.

Installation notes: prepare a clean work area and basic hand tools such as a hex driver and small screwdrivers, keep original screws and check thread engagement during reassembly, and avoid overtightening to prevent damage to mating parts.