This is an aluminium front arm plate designed for the Kyosho Mini Inferno ST and Mini Inferno 09 series, intended to mount at the front arm location that interfaces with the rear gear box area on the model chassis. It is an RC-scale replacement part meant to fit the original mounting points and support typical suspension and steering linkages used on these Mini Inferno variants.
Installation focuses on direct swap with the stock plate using the existing screw points; no additional tools or modifications are required beyond standard RC maintenance tools. Check fitment on your chassis before final assembly and torque fasteners to match your usual setup to avoid stressing the aluminium around the mounting holes.
In tuning terms this plate provides a rigid mounting surface that helps keep arm geometry consistent under load, so it is used when you want repeatable suspension behavior or when replacing a damaged original part. As an aftermarket alloy piece it serves primarily to restore correct alignment and maintain predictable steering and suspension responses.
Copyright © 2008-2026 rcjaz.com All rights reserved
