KYOSHO Mini Inferno/Mini Inferno ST Graphite Steering Servo Plate by 3Racing MIF-046/SG  [MIF-046/SG]

Graphite steering servo plate for Mini Inferno

This graphite steering servo plate is a scale RC accessory designed for Kyosho Mini Inferno and Mini Inferno ST chassis. Made from graphite to resist flex in the steering assembly, the plate serves as a direct replacement for the plastic stock part to offer a firmer mounting point for the servo and steering linkages.

Compatibility is limited to the Kyosho Mini Inferno and Mini Inferno ST models named above. The part focuses on structural improvement at the servo mounting area only, it does not include electronics or servos.

Installation is straightforward for users familiar with basic chassis disassembly: remove the original servo plate, transfer the servo and any linkage hardware to the graphite plate, align the servo so the horn centers correctly, and install using the original mounting points. Take care not to over-tighten fasteners to avoid introducing stress to surrounding chassis parts.

In tuning terms, a graphite servo plate reduces mounting flex that can blur steering input, so expect a firmer steering feel and more consistent feedback at the wheel. When adjusting handling, consider this plate as one element among tire choice, steering ratio, and suspension setup; test incremental changes rather than large simultaneous adjustments.