This alloy front knuckle arm holder is an aftermarket replacement part produced by GPM for Kyosho Mini-Z AWD platforms, supplied as a 1pc set with mounting screws included. It replaces the factory steering arm mount to provide a stiffer, machined metal interface between the hub carrier and the steering linkage, helping reduce flex under load and producing a more repeatable steering response during on-track adjustments.
Intended use is strictly for Mini-Z AWD scale RC models; the component supports tuning work where front-end rigidity and steering feedback are being adjusted. The 1.0mm thickness specification provides a balance between added stiffness and minimal weight penalty, making it suitable for drivers who want a firmer steering feel without major changes to suspension geometry.
Installation notes: the part is supplied with screws and mounts in place of the original knuckle arm holder. Check thread fit and hardware tightness after initial runs and recheck during setup sessions to ensure consistent steering behaviour. The item is described as alloy construction and should be treated as an RC-scale spare part only.
Copyright © 2008-2026 rcjaz.com All rights reserved
