KYOSHO Mini-Z AWD Alloy Front/Rear Sinkage Rims 3.5mm Offset by GPM MZA503F/R/+3.5  [MZA503F/R/+3.5]

Mini-Z AWD Alloy Sinkage Rims

This is a set of alloy sinkage rims made for KYOSHO Mini-Z AWD platforms, intended as a direct wheel upgrade for scale RC use. The design focuses on wheel fit and clearance control so you can fine-tune track clearance and tyre seating without changing hubs or driveshaft geometry.

Key attributes are shown in the product name: 5p bolt pattern, 3.5mm offset and 8.5mm nominal width, in an aluminium alloy construction. Use these rims when adjusting scrubbing, stance, or when swapping tyre profiles; they work with standard Mini-Z AWD wheel nuts and common hex adapters used on MR-03 AWD setups.

Installation notes: remove the existing wheel, verify hex adapter alignment and clearance around suspension and bodywork, then mount the rim and hand-tighten the wheel nut before a final torque check. After fitting, roll the car to confirm tyre seating and steering range, and check for any rubbing at full lock.