Kyosho Mini-Z AWD Alloy Rear Knuckle Arm Holder (0.6mm, Toe In 0.2mm) by GPM MZA031R+0206  [MZA031R+0206]

Aluminum rear knuckle for Mini-Z AWD

This GPM design rear knuckle arm holder is an alloy replacement part intended for Kyosho Mini-Z AWD platforms, supplied as an RC-scale accessory for tightening the rear hub mounting and setting a fixed 0.2mm toe-in. The 0.6mm alloy plate provides a firmer mounting surface compared with thin stamped parts, helping maintain a consistent rear geometry during routine setup and race-day adjustments.

Use this part when you need a repeatable rear toe setting and a durable mounting point for the knuckle arm on Mini-Z AWD cars. It accepts standard Mini-Z knuckle hardware and replaces the original plastic/aluminium holder, offering predictable alignment for small-scale tuning work.

Installation and tuning notes

• Verify compatibility with your Mini-Z AWD chassis before fitting, align the knuckle arm and hand-thread fasteners to avoid cross-threading.
• The part sets toe-in at 0.2mm; treat it as a fixed geometry shims solution rather than a dynamic adjustment item.
• Check clearance around the suspension and motor area after installation to avoid interference with the motor or wiring on AWD layouts.