This alloy rear knuckle arm holder is a single-piece replacement designed for Kyosho Mini-Z AWD applications, supplied as 1 pcs. The part is made from aluminum alloy and specified with a 0mm offset and a 1.0mm plate thickness as indicated in the product name.
As an RC-scale component, its role is to secure the rear knuckle arm to the hub assembly while offering a more rigid mounting surface compared with softer materials. In tuning terms, swapping to an alloy holder can reduce flex at the knuckle interface, which affects rear-end response and consistency during lap-to-lap setups on indoor or small-scale tracks.
Installation follows the original Mini-Z AWD knuckle arm mounting points and uses the vehicle’s existing fasteners, so no modification to the chassis geometry is required. Check alignment and clearance after fitting to ensure free suspension travel and correct wheel camber under load.
Copyright © 2008-2026 rcjaz.com All rights reserved
