Kyosho Mini-Z AWD Alloy Rear Knuckle Arm Holder (Toe In 0.4mm, Thick 1.0mm) by GPM MZA031R+0410  [MZA031R+0410]

Alloy rear knuckle holder for Mini-Z AWD

This alloy rear knuckle arm holder is an aftermarket replacement part produced by GPM for Kyosho Mini-Z AWD models, supplied as a single pcs unit. The plate is described with a 1.0mm thickness and a built-in toe‑in offset of 0.4mm, intended for small-scale rear suspension geometry adjustments on Mini‑Z AWD platforms.

Fit and role: the part serves as the rear hub pivot mount that secures the knuckle arm and defines toe angle at the rear axle on MR‑03 AWD style Mini‑Z chassis. Use it when replacing worn plastic carriers or when testing minor static toe changes to influence handling balance at the rear.

Installation notes: standard Mini‑Z disassembly applies, remove the rear hub assembly, swap the stock carrier for this alloy holder, and reuse original screws and bearings where applicable. Check for correct clearances after fitting and confirm the knuckle rotates freely without binding. No additional hardware is included unless specified by the vendor.