This pair of alloy rear rims is made for Mini-Z AWD micro cars and supplied as 1 pr (2 pcs). The listing identifies the wheel as an alloy rear wide sinkage rim with an 11mm width, 0mm offset and 18p bolt pattern. The design targets rear-end wheel width and seating for wider tyre profiles commonly used in Mini-Z AWD setups.
Compatibility is focused on the Mini-Z AWD platform. The rims are an RC-scale replacement or tuning option intended to change rear track width and tyre fitment; verify hub fit and wheel hex interface on your chassis before installation.
Installation notes: remove existing rear wheels and confirm the wheel hex engages cleanly with the rim hub, then secure using the original wheel nuts or hardware sized for 18p hole spacing. During setup check tyre seating and run a low-speed test to confirm there is no rubbing against bodywork or suspension parts. For tuning, wider rear rims can alter corner entry and rear traction behavior, so adjust spring rates and sway settings accordingly to rebalance handling.
Copyright © 2008-2026 rcjaz.com All rights reserved
