KYOSHO Mini-Z AWD Delrin Front/Rear Ridge Rims with Tires 5p 0mm offset Width 8.3mm by GPM DMZA601RW+1.5  [DMZA601RW+1.5]

Mini-Z AWD Delrin ridge rims with tyres

These Delrin front and rear ridge rims are produced for Kyosho Mini-Z AWD platforms and supplied as a one pair set (1pr set) including tires. The rims are specified as 5p, 0mm offset with an 8.3mm width and are molded from Delrin for dimensional stability in scale RC use.

In practice these wheels serve two roles: a direct replacement for worn Mini-Z AWD wheelsets, and a tuning option where rim material and width influence handling characteristics. Delrin keeps weight low while keeping a consistent shaft-to-hub interface, and the ridge profile helps the tire bead settle for repeatable lateral response on typical Mini-Z surfaces.

Installation is straightforward on stock Mini-Z AWD hubs using the standard wheel hex and hardware. Verify hub fit and clearances on your specific MR-03 AWD or Mini-Z AWD variant before full use, and balance tires if needed for high-speed laps. Avoid using these parts on full-size vehicles as they are intended only for RC-scale applications.