Kyosho Mini-Z AWD Rear Knuckle Arm Holder Toe In +0.1mm by GPM MZA031R/+0.1  [MZA031R/+0.1]

Rear knuckle arm holder for Mini-Z AWD

This aluminium alloy rear knuckle arm holder is an aftermarket replacement part designed for Kyosho Mini-Z AWD applications, provided as 1 pcs. It accepts a +0.1mm toe‑in setting to alter rear toe geometry in small‑scale setups without changing the upright or hub spacing.

Functionally, the holder positions the rear knuckle arm to achieve the stated Toe In +0.1mm offset. On a Mini‑Z AWD MR-03 chassis this change is intended for incremental tuning—use it when you want a subtle increase in rear toe-in to refine turn‑in balance and in‑corner behavior on track layouts typical for Mini‑Z racing.

Installation is straightforward for a modeller familiar with Mini‑Z maintenance: remove the stock holder, fit the alloy unit in the same mounting points, and secure with the original hardware. Use the correct size hex driver, avoid overtightening, and recheck alignment and clearance after installation. Inspect surrounding parts and bearings when replacing plastic components.