KYOSHO Mini-Z AWD Rear Toe In/Out Linkage 1 Degree by 3Racing AWD-09/1  [AWD-09/1]

Rear toe linkage for Mini-Z AWD

This rear toe in/out linkage is a scale replacement part intended for Kyosho Mini-Z AWD setups, supplied under the 3Racing AWD-09/1 part number. It provides a focused way to alter rear toe by 1 degree increments so users can fine-tune balance between rear grip and turn-in response on small-scale tracks.

Fitment and role: the linkage is made for Mini-Z AWD chassis layouts where rear toe adjustments are possible, and its primary role is tuning corner entry and mid-corner stability rather than changing overall steering geometry. Small toe changes affect traction transfer and the rear end's willingness to rotate, so adjustments should be modest and tested incrementally.

Installation and notes: the part installs in place of the standard rear toe link on compatible AWD Mini-Z layouts. Check alignment at ride height and verify symmetry left-to-right after fitting. Because the specification changes toe by roughly 1 degree, test under controlled runs and adjust only a single increment at a time to observe handling differences.