Kyosho Mini-Z AWD Rear Toe In_Out Linkage 3 Degree by 3Racing AWD-09/3  [AWD-09/3]

Rear toe linkage for Mini-Z AWD

This is an RC-scale rear toe in/out linkage designed for Kyosho Mini-Z AWD chassis, intended to replace the stock rear linkage to allow repeatable 3° toe settings. The part is supplied in purple color and is meant for model-level tuning and setup work on Mini-Z AWD cars.

Functionally the linkage changes how the rear toe is set and allows drivers to make small, measured adjustments to rear-end geometry. Use it when you need a defined 3° toe baseline for corner entry stability or when swapping between different handling setups during practice sessions.

Installation notes: remove the existing rear toe linkage on the Mini-Z AWD, transfer any required ball cups or spacers from the original part, and fasten the replacement using the original hardware. Confirm thread engagement and that the linkage moves freely through its range without binding before running the model.

Tuning tips: start from the stock toe setting and compare handling with the 3° linkage fitted, make incremental changes to rear toe in combination with front toe and roll center settings, and test on a consistent surface to judge the impact on cornering balance. Small toe changes affect turn-in and mid-corner rotation more than straight-line stability.