KYOSHO Mini-Z F1 Front Toe In/Out Linkage 0 Degree by 3Racing MKF-02/0  [MKF-02/0]

Front toe linkage for Mini-Z F1

This is a scale front toe in/out linkage designed for KYOSHO Mini-Z F1 chassis, supplied as the 3Racing MKF-02/0 replacement part. It establishes a fixed 0 degree toe setting at the front end to provide a neutral baseline for steering geometry when setting up a Mini-Z F1 on track or during bench tuning.

Compatibility is limited to Mini-Z F1 variants that use the front linkage mount style found on KYOSHO Mini-Z F1 models. The part is intended as a direct-fit replacement or alternative to stock linkage pieces where a 0 degree toe reference is required for handling checks or incremental adjustments.

Installation notes: remove the existing front linkage following the chassis manufacturer’s procedures, check existing ball studs and steering posts for wear, and secure the linkage with the original hardware. Use the chassis’ toe adjusters or alternate-length linkages to change toe settings if needed, keeping track of left/right symmetry and tie-rod angles to avoid binding.

Tuning role: fitting a 0 degree front linkage gives a neutral starting point for steering response, letting you evaluate other suspension and roll characteristics without toe-induced understeer or oversteer bias. Swap to other linkage angles to explore toe-in or toe-out effects during corner entry and mid-corner behavior.

As an RC-scale spare, this linkage serves as a practical option for resets, spares, and controlled tuning sessions on Mini-Z F1 chassis using the standard KYOSHO front linkage interface.