Kyosho Mini-Z MR-015 2mm Aluminum Lock Nuts by 3Racing 3RAC-N20/LB/V2  [3RAC-N20/LB/V2]

2mm aluminum lock nuts for Mini‑Z MR‑015

These 2mm aluminum lock nuts are an RC-scale replacement part supplied in a 10 pcs pack and are produced for use with Kyosho Mini-Z MR-015 assemblies. The light blue anodized finish identifies the part visually while the aluminum construction offers a balance between corrosion resistance and lightweight fitment suited to small-scale chassis hardware.

Use this set where 2mm lock nuts secure wheel hubs, suspension linkages or other small fastenings on the MR-015 chassis. They function as a mechanical lock nut to reduce the chance of loosening under vibration; proper installation helps maintain setup stability during short track runs and practice sessions.

Installation notes: thread the nut onto the mating 2mm screw until hand-tight, then apply a small final turn with the appropriate hex driver or wrench. Avoid excessive torque to prevent thread or component damage. For repeatable service, check tightness after the first few runs and retorque lightly as necessary.