Kyosho Mini-Z MR-02 Aluminum 5-Spoke Rear Rim +0.5 Offset by 3Racing MR02-RP05/LB  [MR02-RP05/LB]

Aluminum rear rim for Mini-Z

This is an RC-scale rear wheel rim produced by 3Racing for Kyosho Mini-Z platforms. The part is an aluminum 5-spoke rear rim in a two-tone light blue finish with a +0.5 offset, intended for fine wheel spacing and low-level tuning on Mini-Z nitro or electric on-road set-ups that accept Mini-Z MR-02 and MR-015 rear wheels.

Compatibility is limited to the listed Kyosho Mini-Z models; confirm your chassis uses the same rear wheel mounting style before fitting. The +0.5 offset changes effective track width at the rear and can help with tyre clearance and balance when adjusting roll centre or camber behavior on a small scale.

Installation notes: swap this rim into the existing rear tyre and hub assembly used on the compatible Mini-Z models, check tyre seating and glue where appropriate, and verify clearance with the body shell at full suspension travel and steering extremes. Inspect wheel hex engagement and tighten to the original torque to avoid loosening during running.