Kyosho Mini-Z MR02-LM 2° Aluminium Steering Block by 3Racing KZ-15/2/TI  [KZ-15/2/TI]

Aluminium Steering Block for Mini-Z MR02-LM

This is an aluminium 2° steering block produced for use on Kyosho Mini-Z MR02-LM chassis, supplied under the 3Racing part code KZ-15/2/TI. It is an RC-scale replacement part that replaces the stock plastic steering block to offer a firmer mounting point for the steering assembly and to support repeated disassembly during maintenance.

The component is intended for direct-fit replacement on Mini-Z MR02-LM based assemblies that accept the MR-015 steering block form factor. Installation is a straightforward swap: remove the original steering block, transfer any bearings or bushings as required by your existing layout, then secure the aluminium unit using the original hardware. Check alignment after installation and adjust toe or steering trim through your transmitter or steering linkages as needed.

In tuning terms this steering block is a minor but practical part for drivers who manage steering feel and repeatability. The 2° specification describes the fixed steering geometry offset it provides, making it suitable when a marginal change to steering angle or response is part of your setup workflow.