Kyosho Mini-Z Overland Nylon Ball Ends by GPM MOL1332/BE  [MOL1332/BE]

Nylon ball ends for Mini-Z Overland

This RC-scale accessory replaces and updates ball end terminations on Mini-Z Overland linkages, supplied as a pair set referenced by MOL1332/BE. Made from nylon, the parts are intended for linkage and suspension connections where smooth articulation and reduced binding are desired.

Fit and role: the ball ends serve as the pivot between control arms and turnbuckles or steering linkages, affecting geometry and responsiveness; use them where the original metal or worn ball ends need replacement or when a slightly freer movement is required for tuning.

Installation notes: fit the ball end onto the existing ball stud and confirm proper thread engagement where applicable, avoid over-tightening to prevent stripping, and check clearance after installation to ensure there is no interference with nearby components. Periodic inspection is recommended for wear when used in frequent running.

Tuning guidance: swapping to nylon ball ends can slightly soften linkage friction compared with harder materials, which may smooth minor twitching without changing fundamental geometry; use them as part of an incremental tuning approach rather than a primary setup change.