Kyosho Motor Cycle Alloy Bearing Steering Set by GPM KM048  [KM048]

Alloy steering set for Kyosho motorcycles

This GPM KM048 alloy steering set is an RC-scale replacement part designed for Kyosho motor cycle models, supplied as a 1pc set and including the required mounting screws while excluding the 8x12 ball bearing specified in the original listing.

The component is machined aluminium intended to replace worn or plastic steering housings, improving interface rigidity between steering linkages and the front assembly without altering electronic components such as servos, ESCs, or motors.

Installation notes: the set fits into existing Kyosho motorcycle steering assemblies that accept an 8x12 ball bearing (not included), use standard hand tools to remove the stock housing, verify bearing seat alignment, then secure the alloy part with the provided screws. Check steering throw and endplay after fitting and make small trim adjustments to linkage lengths if required for neutral steering.

Tuning role: use this alloy steering housing to reduce flex at the front end for crisper steering response when adjusting toe-in, caster, or steering dampening; it is a chassis-level hop-up intended to complement suspension and linkage tuning rather than replace those adjustments.