KYOSHO Motor Cycle Alloy Front Wheel (4 Swirl) by GPM KM0504F  [KM0504F]

Alloy front wheel for Kyosho motorbikes

This alloy front wheel is a drop-in replacement intended for Kyosho motor cycle models in scale RC use. The 4-swirl design addresses wheel stiffness and mass distribution while remaining an aftermarket option produced by GPM for Kyosho platforms.

Fit and installation are straightforward for users familiar with motorcycle-scale hubs: remove the old wheel, verify hub and bearing interfaces, then secure the replacement using the original axle and fasteners. Confirm run-out and balance after installation to maintain predictable steering and handling.

The wheel’s role in tuning is practical—changing front wheel mass and rigidity affects steering feedback and suspension response on model tracks, so treat this part as a handling adjustment rather than a standalone performance upgrade.

Use this wheel when replacing worn front rims or when tuning steering characteristics; always check bearing fit and axle clamp torque, then test at low speed before full operation.