Kyosho Motor Cycle Aluminium Rear Wheel Holder by GPM KM888  [KM888]

Aluminium rear wheel holder for Kyosho

This aluminium rear wheel holder is an RC-scale replacement/hop-up intended for Kyosho motorcycle models, supplied as a single set. Built for hobby use, the part secures the rear wheel assembly and serves as a rigid mounting point during track runs or bench setup.

Designed to work with Kyosho motorcycle chassis that accept a bolt-on rear wheel support, the holder focuses on maintaining axle alignment and simplifying wheel removal and re-install. The aluminium construction improves resistance to deformation compared with stock plastic parts while remaining suitable for routine RC maintenance.

Installation notes: the holder replaces the stock rear wheel mount and installs using the vehicle's existing mounting points and fasteners. For fitment, confirm the original mounting geometry on your Kyosho motorcycle before fitting, and use correct thread engagement and threadlocker where applicable. No special tools beyond common RC workshop tools are required for standard installation.

Role in setup and tuning: use this holder when you need stable wheel location for setup checks, bearing swaps, or when running stiffer suspension settings that transfer more load to the wheel mounts. As an aftermarket aluminium part, it is intended to offer a straightforward, durable alternative to original components without changing wheel geometry.