Kyosho Motorcycle Alloy Front Wheel Flat (5H) by GPM KM0205F  [KM0205F]

Alloy front wheel for Kyosho motorcycles

This is an RC-scale front wheel designed for Kyosho motorcycle kits, offered as an aftermarket replacement or upgrade by GPM. The flat profile with a 5-hole mounting pattern suits applications where a low-profile wheel is required for scale appearance or specific tyre fitment. The neutral alloy construction provides a stiffer mounting surface compared with some plastic originals, helping maintain wheel roundness under moderate loads.

Installation is straightforward for users familiar with typical motorcycle wheel hubs on Kyosho kits: remove the original wheel, check hub alignment and hex fitment, then secure this wheel using the existing mounting hardware. Verify the 5H bolt pattern and axle clearance before final tightening to avoid thread or hub interference.

For tuning and setup, this wheel functions primarily as a structural component affecting tyre seating, balance, and rotational stiffness. Use it when adjusting scrub radius, tyre profile clearance, or when fitting custom tyres that require a flatter rim face. After installation, perform a static and dynamic balance check and confirm clearance with suspension and bodywork during full travel.

Use this alloy front wheel when you need a durable, low-profile rim for Kyosho motorcycle models; confirm fit before final assembly and rebalance after mounting tyres.