Kyosho Motorcycle Alloy Swing Arm by GPM KM014  [KM014]

Alloy swing arm for Kyosho motorcycles

This is an RC-scale alloy swing arm intended for Kyosho motorcycle models, supplied as a single-piece set with matching screw and washer for straightforward replacement. The component is cast/machined from an alloy as stated in the product name and serves as a direct structural part of the rear swing linkage on scale motorcycles.

The part is designed to replace a worn or damaged swing arm, or to provide a stiffer alternative for chassis tuning. Installation typically requires removal of the rear wheel and linkage pins, inspection of associated bearings, and re-torque of fasteners to maintain alignment. Use appropriate thread-lock on steel fasteners if the original design calls for it.

Tuning notes: an alloy swing arm alters flex characteristics compared with stock plastic parts, which can change rear-end feedback and traction. Small changes in axle alignment or bearing preload may be needed after fitting; test runs at low speed are recommended to verify chain/drive alignment and suspension travel.

This KM014 alloy swing arm by GPM is a straightforward replacement and tuning part for Kyosho-scale motorcycles, intended for hobbyist maintenance and chassis setup adjustments.