Kyosho Motorcycle C10 Aluminium Steering Arm by GPM KM026  [KM026]

C10 steering arm overview

This aluminium steering arm is an RC-scale replacement part produced by GPM for Kyosho Motorcycle C10 platforms, supplied as 1pcs. It is intended for hobby use on model motorcycles where a metal steering arm is preferred over standard plastic components to provide firmer steering linkage and consistent geometry under load.

Fit and role: the part replaces the original steering arm on compatible Kyosho motorcycle C10 assemblies and acts as the link between the servo output and the front steering assembly. As an aluminium component it offers greater stiffness compared with common molded parts, which helps preserve steering geometry during aggressive cornering and when adjusting steering link lengths for tuning.

Installation notes: confirm the C10 designation before fitting, check the servo spline and bolt pattern for match, and ensure the steering travel is free from interference after mounting. Tighten fasteners to secure the arm but avoid over-torquing; inspecting linkage alignment and removing play at the servo and bearings will help achieve predictable steering response.

Practical tuning guidance: use this arm when you need a rigid steering connection for fine tuning steering throw and centring behavior, then make incremental adjustments at the linkage rather than altering the arm geometry itself. The aluminium arm is suitable for routine replacement or for owners seeking a consistent base part for setup iterations.