Kyosho MZN-W01LW - 3D Rear Wing for 720S GT3 (Light Weight) Mini-Z MR-04 body part  [KY-MZN-W01LW]

Kyosho MZN-W01LW - 3D Rear Wing for 720S GT3 (Light Weight)
Price:
USD$15.51
Brand:
Kyosho
Model:
KY-MZN-W01LW
GTIN:
4548565518500
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $12.50 each $6.02 or 19%
3+ $11.88 each $10.89 or 23%
Write a review
alt="Kyosho MZN-W01LW - 3D Rear Wing for 720S GT3 (Light Weight)" title="Kyosho MZN-W01LW - 3D Rear Wing for 720S GT3 (Light Weight)"
alt="Kyosho MZN-W01LW - 3D Rear Wing for 720S GT3 (Light Weight)" title="Kyosho MZN-W01LW - 3D Rear Wing for 720S GT3 (Light Weight)"

3D rear wing for Mini-Z 720S GT3

This Kyosho MZN-W01LW 3D rear wing is an RC-scale body part designed for Mini-Z GT3-style shells that reference the 720S GT3 shape. The component focuses on a low-mass profile and three-dimensional shaping to influence airflow behavior at model speeds without implying full-size vehicle use.

Compatibility and fitment: this wing is intended to match Mini-Z bodies styled after the 720S GT3 and to work with MR-04 based setups where standard rear wing mounts are used. Confirm body post spacing and mount points on your specific shell before final installation.

Installation notes: install using the original wing mounts or light M3 hardware where appropriate, avoid over-tightening to prevent stress on thin mounting tabs, and check clearance with the body to ensure the wing does not contact the body or tyre during suspension travel or chassis flex.

Tuning role: on micro-scale circuit layouts the wing serves as a tuning element for rear grip and transient balance; small angle or height changes can shift yaw/stability characteristics, so make incremental changes and test laps before further adjustments.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What bodies and chassis is this wing compatible with?

The wing is made for Mini-Z bodies styled after the 720S GT3 and intended to fit MR-04 based setups using standard rear wing mounts, confirm your shell's post spacing before fitting.

What material is the wing made from?

The wing is a lightweight molded plastic component designed for model-scale aerodynamic tuning; treat it as a body accessory rather than a structural chassis part.

Any tips for installing without damaging mounting tabs?

Use light M3 fasteners or the original Kyosho hardware, hand-tighten to avoid cracking thin tabs, and consider small nylon washers to spread load if needed.

How does the wing affect handling on the track?

Small changes in wing angle or ride height can tweak rear grip and rotation; use short test runs to evaluate changes and avoid large, simultaneous adjustments to other setup items.

Copyright © 2008-2026 rcjaz.com All rights reserved