Kyosho MZW131 - Mini-Z Setting Shim set (0.2mm/2pcs.)  [KY-MZW131]

Mini-Z 0.2mm setting shims

This Kyosho MZW131 shim set is an RC-scale accessory supplied as two 0.2mm shims intended for small adjustments on Mini-Z models. The parts are sold as a simple set to alter clearances where small, repeatable spacing changes are useful.

Compatibility: the product is listed for the Mini-Z series MR-03 chassis. Use these shims when you need incremental spacing changes without modifying parts or machining new components.

Typical uses include fine-tuning gear mesh clearance, correcting small misalignments in transmissions, and adjusting contact points in tight assemblies. Because each shim is thin, you can stack them to reach intermediate thicknesses while keeping changes predictable.

Installation guidance: inspect the assembly to confirm a shim is the correct method for clearance adjustment, place the shim between the mating surfaces that require spacing, verify moving parts rotate freely after fitting, and recheck clearances under light operating load. Avoid overcorrecting by adding excessive shim thickness.

Handling note: keep the two pcs together and label thickness if you store additional shim sizes, so that future tuning remains consistent with prior setups.