Kyosho V One RRR Handle Bar by 3Racing V3R-028  [V3R-028]

Handle Bar for Kyosho V One RRR

This is an RC-scale handle bar intended as a direct replacement for Kyosho V One RRR and V One RRR Evo steering assemblies. The part focuses on restoring or refining the steering linkage and front-end geometry without changing chassis layout.

Fitment and role: the bar installs where the original steering link or handle bar locates, serving to maintain correct tie-rod alignment and steering response. It is intended for on-road RC chassis use and should be treated as a service or tuning item rather than a performance upgrade alone.

Installation notes: remove the stock handle bar, confirm link lengths and pivot alignment, fit the replacement part and verify free movement of the steering links through full travel. Check for any binding and adjust toe and steering centring as needed after installation. Use the existing mounting points and fasteners; inspect link ball seats and bearings during the swap.

Tuning considerations: when replacing the handle bar as part of setup changes, re-check front-end geometry and steering throw. Small changes to link lengths or pickup points affect turn-in and mid-corner balance, so confirm handling on a short test run and refine gradually.