This Kyosho SCW032 CNC Arm Shaft Block2 is a two-piece replacement designed for the Tomahawk 85 WC platform and noted as usable with the Scorpion Series. The part functions as an arm shaft block for the suspension/arm pivot area, supplied as 2pcs for single-side replacement or paired servicing.
Intended role: it secures the arm shaft pivot and helps control lateral play where the arm interfaces with the chassis. Technically described as a CNC-type block, it is used during routine maintenance or when swapping worn pivot components to restore drivetrain geometry and steering feedback on scale electric cars.
Installation notes: this block fits into the existing arm assembly location and is installed using the original fasteners and hardware from the vehicle it supports. Standard RC maintenance tools such as a hex driver and basic hand tools are typically sufficient for replacement; check existing fastener condition and thread engagement during reassembly.
Tuning role: replacing worn arm shaft blocks can tighten axle alignment and reduce unwanted slop, which in turn affects suspension response and steering consistency; use this part when diagnosing play at the arm pivot or when rebuilding the front/rear arm assemblies.
Use Kyosho SCW032 when restoring pivot stability on Tomahawk 85 WC or when a direct-fit replacement is needed for Scorpion Series maintenance tasks.
Copyright © 2008-2026 rcjaz.com All rights reserved
