This is an RC-scale replacement adjust shock case intended for use with the Tomahawk 85WC chassis. The part is sold as the adjust shock case S in red and is intended to replace worn or damaged shock housings without altering original suspension geometry.
Functionally the component serves as a housing for the shock assembly and supports routine maintenance and tuning. It is designed to allow standard disassembly and reassembly procedures used on 1/10 scale Tomahawk models, and to provide a stable mounting point for shock internals during setup changes.
Installation notes: remove the shock from the suspension arm and disassemble the shock following the chassis service routine, transfer internal components into the replacement case, confirm seal and shaft alignment, then reinstall and check ride height and damping behavior before track use. No specialized tools beyond common hobby hex drivers and basic shock tools are required.
Copyright © 2008-2026 rcjaz.com All rights reserved
