This rear suspension arm set is intended as a direct spare for FW-06 style 1/10 touring chassis using the RRR/SIII rear layout. The parts restore original mounting points and provide the expected geometry for rebound and roll characteristics used in standard setups.
When replacing arms, inspect hinge pins and rear hub mating faces for wear before fitting. Clean mounting surfaces and confirm the arm pivots move freely through their full travel. Check wheel toe and camber after installation to verify the chassis holds previous setup values.
Typical practical uses:
Compatibility notes: designed for FW-06 category chassis with the rear RRR/SIII mounting pattern. Confirm your vehicle’s rear hub and hinge-pin layout match this pattern before purchase.
Copyright © 2008-2026 rcjaz.com All rights reserved