LOSI LMT 4WD Solid Axle Monster Truck Differential Case Medium Carbon Steel + 7075 Aluminium by GPM LMT011  [LMT011]

Differential case for LOSI LMT

This replacement differential housing is an RC-scale part designed for LOSI LMT solid axle monster truck platforms, built to locate and protect the internal bevel gears inside the front, centre and rear assemblies. The outer shell is medium carbon steel to improve strength and wear resistance, while the central section is machined from 7075 aluminium to reduce rotating mass where it mounts in the axle assembly. A rubber sealing ring is included to improve oil and dirt sealing around the case.

The component’s role in setup and tuning is straightforward: it holds the differential gears in correct mesh, helps maintain gear alignment under load, and provides a stiffer mounting than the stock plastic housings. That stiffness supports predictable gear behaviour during aggressive throttle and on rough surfaces.

Installation notes: the package includes the required fasteners and shims to assemble the unit into the axle or centre gearbox, replace the internal gears into the new housing, and reseal the unit. Verify gear lash and bearing endplay after installation and use the supplied aluminium shims as needed to correct mesh and preload.

Choose this aluminium-steel differential case when you need a direct-fit replacement that improves structural rigidity and sealing for LOSI LMT solid axle monster truck diffs; check gear mesh and bearings during reassembly.