This red anodized aluminum rear caliper is an RC-scale replacement part intended for Promoto-MX motorcycle models. It serves as a direct spare for the rear braking assembly on Promoto-MX chassis variants and is supplied by JAZRIDER under model JR-LMX06-RD.
The component focuses on straightforward serviceability and visual consistency. As an aluminum caliper it provides a rigid mounting point for brake pads and links, and the anodized finish helps resist surface wear from handling and environmental exposure typical of dirt track use.
Installation and tuning notes: fitment assumes Promoto-MX rear mounting points and brake linkage layout are retained, so installation is typically a bolt-on replacement using the original hardware. When installing, check pad alignment and lever travel before operation, and perform small adjustments to braking geometry as needed to match your existing setup.
Use cases: replacement for damaged stock parts, spare for maintenance cycles, or to maintain consistent braking feel after chassis modifications; intended only for RC motorcycle models and track conditions common to dirt bike layouts.
Copyright © 2008-2026 rcjaz.com All rights reserved
