This 44mm steering rod set is produced for the Mugen MBX-6 platform and supplied as two pcs, made from titanium to reduce weight while retaining fatigue resistance for RC-scale steering links. The component serves as a direct replacement for worn or damaged steering links where the same length and mounting interfaces are used.
Functionally, the part is intended to stabilise front-end response by providing a lightweight linkage between servo output and steering knuckles. Titanium offers a balance of lower mass and improved durability compared with standard steel links, which can help maintain consistent steering geometry during repetitive use.
Installation notes: confirm the rod length and ball-end or rod-end interface match your MBX connections before fitting, check thread engagement and secure fasteners to the vehicle's recommended torque to avoid loosening under load, and inspect joints after initial runs for correct range of motion and clearance.
Use these rods when matching length and end fittings are required for MBX-6 steering repairs or when a lighter linkage is desired for more consistent steering feel during track tuning.
Copyright © 2008-2026 rcjaz.com All rights reserved
