MUGEN MRX5 7075-T6 Servo Saver Steering by Arrowmax AM-MRX5-H2803-T  [AM-MRX5-H2803-T]

Servo saver for MRX5 steering

This Arrowmax AM-MRX5-H2803-T servo saver steering is an RC-scale replacement part produced for the MUGEN MRX5 chassis. The component is machined from 7075-T6 aluminum and supplied with a bearing to reduce friction at the steering pivot. The design emphasizes increased structural stiffness while keeping mass low relative to typical alloy upgrades.

Fitment is intended for the MRX5 steering assembly and uses the chassis’s existing mounting arrangement. Installation normally involves removing the stock servo saver and refitting this unit in the same location, reusing the original linkage and fasteners where applicable. Verify alignment and bearing seating during installation to avoid binding.

On-track, a stiffer servo saver can make steering inputs more consistent and improve repeatability when tuning toe and steering throw. Use this part when you require a firmer steering response for setup work or when testing suspension and steering geometry changes on the MRX5.

Use this machined alloy servo saver when targeting firmer steering feedback and precise pivot action on the MRX5 chassis; confirm fit and bearing orientation during installation.