Mugen MRX5 Servo Saver Frame 7075-T6 by Arrowmax AM-MRX5-H2312-T  [AM-MRX5-H2312-T]

Servo saver frame for Mugen MRX5

This Arrowmax AM-MRX5-H2312-T servo saver frame is a direct-fit RC-scale accessory designed for the Mugen MRX5 chassis. Machined from 7075-T6 aluminium, the part combines a lightweight profile with increased stiffness to reduce flex in the servo mounting area.

As a tuning component it focuses on stabilising the servo linkage and preserving original geometry under load, which helps maintain consistent steering feel and repeatable setup results. The frame replaces the stock saver to give a firmer mechanical interface between servo horn and steering assembly.

Installation is straightforward for hobbyists familiar with MRX5 assemblies: remove the original saver frame, transfer existing hardware where applicable, and secure the Arrowmax unit with the original mounting screws. Check spline alignment and servo horn position before final tightening to avoid pre-load on the servo.

Compatibility

Compatible with Mugen MRX5 chassis only.

Use this frame when seeking a firmer servo mounting solution for MRX5 tuning work; pair with careful alignment and routine hardware checks to get the intended improvement in steering consistency.