Mugen Seiki MTX-4 Rear Brace RH Aluminium by 3Racing MTX4-08/TI  [MTX4-08/TI]

Aluminium rear brace for MTX-4

This is a right-hand aluminium rear brace designed for the Mugen MTX-4 chassis, finished in a titanium look and supplied under the 3Racing part code MTX4-08/TI. It is an RC-scale replacement/upgraded brace intended to work with the MTX-4 rear assembly to influence chassis rigidity and rear-end behaviour.

The brace installs using the MTX-4’s existing rear mounting points and replaces the stock RH rear brace without requiring chassis modification. Its role is to provide a stiffer connection at the rear bulkhead, helping hobbyists tune rear stiffness and transient traction through setup changes rather than altering suspension geometry.

When fitting, check existing hardware for wear and reuse original screws where applicable to retain factory alignment. Use common RC tools such as hex drivers sized for your model’s fasteners, and verify clearance around the body mounts and shock tower during initial installation.