Schumacher FT9 Front Lower Suspension Arm by Factory Pro O-SCP039F  [FP-O-SCP039F]

Front lower suspension arm overview

This is a Factory Pro aftermarket replacement lower suspension arm designed for the Schumacher FT9 touring chassis, supplied as 1pc. The part serves as a direct-fit front lower arm used in routine maintenance and setup changes on FT9-scale RC cars.

Intended use: replace a worn or damaged stock front lower arm, check fitment at the suspension ball stud and pivot pin locations during installation, and verify alignment and roll-center after swapping parts. The arm is an RC-scale component and is not for full-size vehicle use.

Installation notes: remove the front wheel and hub assembly to access the lower arm mounting, retain or inspect existing pivot hardware and bushings, install the new arm in the same orientation and torque fasteners to your chassis service recommendations. After installation, confirm steering geometry and suspension travel on a stand before track use.

Compatibility

Compatible chassis: Schumacher FT9.