This steering hub plate is an aftermarket front-left (FL) replacement fabricated for the Schumacher FT9 1/10 touring car platform, supplied as 1pc for direct swap. It is presented in graphite to offer a different stiffness characteristic compared with standard plastic pieces, and is intended for hobby-level tuning where small changes to steering rigidity are used to refine handling balance.
Installation is straightforward for anyone familiar with FT9 front-end servicing: remove the existing hub plate, transfer any pins or bearings as required, and refit using the original hardware. No special tools beyond standard hex drivers and basic hand tools are required, but check thread engagement and bearing alignment during reassembly to avoid binding.
Tuning role: replacing the stock hub plate with a graphite unit alters local stiffness and resonance. Expect subtle changes to steering feel and response rather than dramatic handling shifts; use this part as part of a measured setup process, testing changes one component at a time to evaluate effects on understeer, oversteer, and steering consistency.
Designed specifically for Schumacher FT9 chassis, listed as front-left steering hub plate, sold as 1pc, intended for RC-scale touring car use only.
Copyright © 2008-2026 rcjaz.com All rights reserved
