Schumacher FT9 Steering Hub Plate RR +1mm Graphite by Factory Pro O-SCP041R  [FP-O-SCP041R]

Overview

This is an aftermarket steering hub plate produced for the Schumacher FT9, designed specifically for the rear right position with a +1mm offset. The component is machined in graphite and supplied as 1pc for replacement or setup adjustments on FT9 touring cars.

Purpose and tuning role: the +1mm hub plate shifts the steering mount location to allow fine adjustments of rear steering geometry; use it when experimenting with handling balance or when replacing worn or damaged hub parts. The part is intended for RC-scale use only and matches the FT9 hub interface.

Installation notes: remove the rear hub assembly and compare fit against the existing plate, confirm bearing alignment and thread engagement, then secure using the original fasteners and the correct hex driver. Avoid over-torquing to prevent stress on suspension components and verify free rotation of the hub and wheel after installation.

• Position: Rear right (RR)
• Offset: +1mm to steering mount
• Material: Graphite
• Quantity: 1pc
• Designed for: Schumacher FT9 chassis