Schumacher Mi10 Front Bulkhead Plate 1mm Graphite by Factory Pro O-SCP045-2  [FP-O-SCP045-2]

Schumacher Mi10 front bulkhead plate

This Factory Pro aftermarket front bulkhead plate is made for the Schumacher Mi10 chassis as an RC-scale accessory, supplied as one pair and finished in Graphite 3.0. The plate sits at the front bulkhead location and is intended to alter front-end stiffness and mounting geometry without changing factory bulkhead layout.

Installation is straightforward for hobbyists familiar with Mi10 assemblies: remove the existing front bulkhead plate, check alignment with the suspension mounts and steering linkages, then reuse the original mounting hardware where possible. No additional tools beyond a hex driver are normally required, and minor trimming of adjacent plastic parts is not expected.

From a setup perspective this 1mm graphite plate provides a modest increase in torsional rigidity at the nose, affecting steering response and front grip characteristics. Use it as part of a stepwise tuning approach, pairing changes with tyre choice, shock settings, and roll-center adjustments to isolate handling effects.