Schumacher Mi10 Rear Bulkhead Plate +1mm Graphite 3.0 by Factory Pro O-SCP046-1  [FP-O-SCP046-1]

Rear bulkhead upgrade for Mi10

This Factory Pro produced rear bulkhead plate is an aftermarket replacement part made for the Schumacher Mi10 RC chassis. It is an RC-scale component fabricated in Graphite 3.0 and specified as a +1mm offset rear bulkhead plate supplied as 1 pair (2 pcs).

The plate replaces the stock rear bulkhead plate to alter rear hub spacing by +1mm, allowing finer adjustments to rear track and rear-end geometry without modifying suspension mounts. Use this part when you need incremental tuning of rear handling balance or to match changed tyre or set-up requirements on the Mi10 chassis.

Installation notes: fit the plate in place of the factory rear bulkhead plate, verify alignment with existing mounting points and bearing seats, and check clearance with the drives and suspension travel after fitting. This component is intended for RC tuning and setup work only.