Scorpion SPCCLIPHK50 Outrunner Motor C-Clip Kit for HK-50 Series  [SPCCLIPHK50]

Outrunner Motor C-Clip Kit

This C-clip kit is made to work with HK-50 series outrunner motors used in RC-scale applications. The parts act as shaft end retention, keeping endbells and rotating assemblies axially located during operation and maintenance.

Use the clips where the motor shaft has a machined groove for snap-fit retention; the set is intended as a low-profile mechanical retainer rather than a bearing or spacer. When servicing, remove the endbell and slide the clip into the shaft groove to restore axial restraint, then reassemble the endbell and verify free rotation without lateral play.

Installation and routine checks help maintain consistent motor alignment and limit unwanted axial movement that can affect gearing and bearing life in RC setups.