Scorpion SPS3014MSK Motor Shaft Kit 5mm Shaft for S-3014 Outrunner Motors  [SPS3014MSK]

S-3014 Series Motor Shaft Kit

This shaft kit is a direct replacement part intended for the Scorpion S-3014 series outrunner motors. It provides a 5mm shaft dimension matching the original S-3014 motor geometry so the shaft seats into the existing bearing bores and lines up with the motor pinion and spur arrangements used in the same motor family.

Use this kit when a motor shows axial play, excessive runout, or when the original shaft is worn from long use or damage. Replacing the shaft restores shaft alignment and helps reduce uneven bearing wear, which can improve motor smoothness and prolong service life when combined with proper bearing inspection.

Installation notes: the kit is designed for direct fit into S-3014 outrunner assemblies and works with the motor's original internal layout. Confirm the shaft seats fully in the bearing journal and that the pinion engagement is correct before final assembly. After installation, check free rotation and minimal wobble at low-speed rotation before reinstallation into the model.