Serpent 110471 Shim 2x4x1 shim for Mini Spyder Monster truck  [SER110471]

Shim 2x4x1 for Mini Spyder

This Serpent 110471 2x4x1 shim is an RC-scale replacement shim sized and named by its nominal dimensions, intended for use on the Serpent Mini Spyder Monster truck RTR EP SER440001 chassis. It functions as a thin spacing element used where small, repeatable changes to stack height, bearing preload, or linkage geometry are required.

Use the shim to fine-tune chassis clearances during setup or maintenance, for example to adjust differential height, motor mount spacing, or to correct small misalignments between mating parts. The part is presented as a concise mechanical spacer rather than a wear item, and it is suitable for situations where a controlled, thin increment is needed to alter handling or fitment.

Installation is straightforward for experienced hobby technicians: identify the mating surfaces that require micro-adjustment, clean contact faces, place the shim in the stacked position, and reassemble ensuring fasteners are torqued to factory or kit recommendations. Check clearances after initial installation and perform short test runs before finalizing setup.