Serpent 402176 Antiroll bar insert (4 pcs) for Medius X26 steel EP (SER400052)  [SER402176]

Antiroll bar insert for X26

This Serpent 402176 antiroll bar insert is an RC-scale spare intended to adjust roll resistance on compatible X26 setups. Sold as a set of 4 pcs, the inserts are designed to change the effective stiffness and response of the antiroll bar without replacing the whole bar assembly, allowing incremental tuning of roll behaviour during practice or setup sessions.

Compatibility noted from the supplied product information points to Medius X26 steel EP (SER400052), so confirm this chassis code when ordering. The inserts act as replaceable contact points inside the antiroll bar linkage or ends, letting you modify lateral compliance and transient roll for balance between front and rear handling.

Installation is straightforward for those familiar with touring car antiroll systems: remove the end links or bar retainers, swap the original inserts with the new set, then reassemble and test on the bench before track runs. No special tools beyond standard hex drivers are typically required, but always follow your chassis maintenance practices and check fastener torque after reinstallation.

Tuning advice: use the inserts to make small, repeatable changes to roll rate rather than large-step adjustments. Combine insert changes with swaybar thickness and shock tuning to achieve predictable understeer/oversteer balance; document each change so you can revert or iterate systematically.

For hobbyists running Medius X26 steel EP platforms, these inserts provide a simple way to refine roll characteristics with minimal parts replacement and fast track-side swaps.