Serpent 402177 steering block mount front l+r for Medius X26 (SER400052)  [SER402177]

Front steering block mount for X26

The Serpent 402177 steering block mount set supplies the left and right front mounting points used on Serpent Medius X26 roadgoing electric kits identified by SER400052. These are RC-scale replacements made to fit the X26 front steering assembly, intended for routine maintenance, repair, or configuration changes on 1/10 electric touring car chassis.

Machined in steel for strength and wear resistance, the pieces serve as the connection between steering knuckles and the steering linkages, influencing toe and steering response. When replacing factory parts, verify handedness (left/right) and retain any original hardware that matches thread size and length.

Installation notes: fit the correct side component to each wheel, thread fasteners by hand first to confirm alignment, and tighten to the wheel hub and steering arm per your chassis manual or previously recorded torque settings. After initial installation, cycle the steering to confirm clearance, then check hub-to-suspension alignment at rest.

Tuning role: these mounts are a structural part of front steering geometry, so material stiffness and mounting offset affect steering feel and feedback. Use them when aiming for consistent toe settings or when swapping hardened components to reduce flex in high-load cornering.